Effective 3-April-2017, Mesa Labs is discontinuing repair service for all stainless steel flexible data loggers with a taper tip. However, we will continue to offer calibration and re-certification for taper-tip loggers in good working condition. Read the entire End of Service Notice here
The MPRF Data Logger armor is specifically tailored to protect the MPRF Temperature Data Logger. Made of Tecaform material plastic, it is thick and form-fitted to protect the logger against more industrialized environments. It is the perfect solution for a rugged environment where the logger may get dropped or thrown, or subjected to liquids. This…
Mesa offers a growing variety of accessories aimed at positioning the logger in the most preferred location for process monitoring. Whether it is a can within a retort sterilizer or a pharmaceutical IV pouch, DataTrace has the accessories to get the most out of your data logging system. Sorted by logger type, this new addition…
The newly redesigned MPIII standoff is now made out of a stronger Ultem design allowing more flexibility of use. The new design is able to withstand much greater rotational force and pressure without breaking. The newly redesigned standoff also incorporates the Ecklund C5 design into its base, allowing easy can mounting. Also included with this…
Monitoring and mapping low temperature freezers can be very difficult. The extreme environment can make it a challenging process to monitor with standard equipment. When using data loggers in this environment, it is necessary to make sure you are using the right battery for the right job. For monitoring low temperatures below -40°C, you need…
When utilizing more than 1 data logger, identifying the location of each specific logger becomes very important to the project itself. Without this, it becomes very difficult to trace what set of data is attributed to which logger at a quick glance. Identifying each logger becomes imperative to the task at hand, yet that doesn’t…
The time spent developing a validation series for a retort or an autoclave, trying to get just the right cycle time, vacuum dwell, or steam injection, can be expensive and nail-bitingly tense. For retorts it’s the grueling cycles that may prove to be wasted labor due to an insufficient dwell time. A typical problem that…
